This is an old revision of the document!
Resistance measurement
Procedure for resistance measurement:
- Set the measuring device to resistance measurement
- Connect the resistance to be measured to the corresponding sockets on the measuring device (the measuring device sockets labeled COM and
- Read the measured value
There are different types of resistance measurement:
- direct resistance measurement
- indirect resistance measurement
Direct resistance measurement
Determine the nominal and measured values of the resistance for (brown, green, orange),
(yellow, violet, red),
(red, violet, red) and the incandescent lamp
. Also measure the approximate resistance
of your body from your right to your left hand.
How do you explain the deviation between and
?
What consequences can have?
Now determine the series and parallel connections of resistors ,
and
.
Specify the formulas used:
=
(=
||
) =
Indirect resistance measurement
The resistances can also be determined by measuring the current/voltage.
Ohm's law: In an electrical circuit, the current increases with increasing voltage and decreases with increasing resistance.
Build the measuring circuit shown in figure 1 for each of the three resistors and set the voltage on the power supply to .
Fig. 1: Indirect resistance measurement
Measure [V] and
[mA]. Calculate
[k
] from these values.
